Silicon rubber heat bed 180W - 12V - 200x200mm

Silicon rubber heat bed 180W - 12V - 200x200mm

The self taping silicon rubber heat pad with a power dissipation of 180W at 12V. Compared to the commonly used PCB heat beds, this silicon rubber heat pad will reach the desired temperature faster due to its higher heating power. The pad is already prepared with a double sited adhesive. To build your 3d printer heat bed you have to attach the pad at an aluminium plate or a CFK plate.
The thermistor with 100k, beta = 3950, is already attached to the pad.

Attention!
Due to the higher power consumtion the heat pad can't connected directly to a RAMPS 1.4 or similar 3d printer controller. The heat bed output of those controllers is not designed to deliver the neccessary 15A at 12v! You have do supply the pad from the powersupply with a relais in between. The heat bed output of the printer controller has to be connected to the control input of the relais.