Products from Lankeda Technology Ltd.

Aluminium MK3 Dual Power Heatbed Aluminium Heatbed MK3 usable with 12V and 24V Dimensions: 214mm x 214mm includes Thermistor 100K B=3950 recommended permanent heating 120°C Powersupply 12V and 24V selectable by connectors based on the...

J-Head Hotend for 1.75mm filament with 0.5mm nozzle J-Head Hotend for 1.75mm filament and 0.5mm nozzle Heat cartrigde 12V ~40W, 6mm diameter, 20mm length Thermistor NTC 100K B=3950 preassembled with around 1m wires

J-Head Hotend for 1.75mm filament with 0.3mm nozzle J-Head Hotend for 1.75mm filament and 0.3mm nozzle Heat cartrigde 12V ~40W, 6mm diameter, 20mm length Thermistor NTC 100K B=3950 preassembled with around 1m wires

Silicon rubber heat bed 180W - 12V - 200x200mm The self taping silicon rubber heat pad with a power dissipation of 180W at 12V. Compared to the commonly used PCB heat beds, this silicon rubber heat pad will reach the desired temperature...

Silicon rubber heat bed 180W - 24V - 200x200mm The self taping silicon rubber heat pad with a power dissipation of 180W at 24V. Compared to the commonly used PCB heat beds, this silicon rubber heat pad will reach the desired temperature...

NTC Thermistor with wiring, 100k, Beta = 3950, 1 piece The thermistor is preconfigured with a wire of around 1m length. Therefore the thermistor is already soldered to the cable and isolated. A connector has to be soldered only at the...

RepRap hotend heater cartrigde 12V ~40W Heater cartridge for RepRap hotends, 12V, around 40W power Dimensions 6mm diameter 20mm length around 1m wires

Mechanical Endstop with cabling Mechanical endstop and wirings. The cable has a length of approx. 70cm.

Opto Endstop with wiring At least 3 endstops are needed for a 3d printer. The endstop is needed for calibrating the printer when a printjob starts. The set contains the optical sensor and a cable with around 70cm length for connecting...

Linear bearing LM8UU Linear bearings LM8UU are perfect for use in a machine with 8mm rods. The linear breaings provide optimal sliding properties along the axes and thus enhance the lifetime and the precision of the printer. inner...

14pcs cables complete wiring set The wiring set is ideal for RepRap 3d printers like Mendel, Prusa, OrdBot Hadron or similar models. Each cable has a length of around 70cm and is finished with pin headers. Product contents: 5x 4pin for...

GT2 Pulley with 20 teeth for GT2 belt, for 5mm shaft 1x GT2 Pulley with 20 teeth matching for 5mm stepper motor shaft 2x set screws