Products from Moko Technology Ltd.
No results were found for the filter!
Arduino Mega 2560 & RAMPS 1.4 & 5x DRV8825 RepRap electronic for controlling a RapRap printer with the following components: 1x Arduino Mega 2560 rev. 3, powerrange 8 - 15V 1x RAMPS 1.4 5x DRV8825 stepper motor driver 5x cooler & cooler pad Cabling set (2 x 2 Pin, 2x 3 Pin, 5 x 4...
€74.90 *
Full Graphic Smart Controller (with cabling) Full Graphic Smart Controller with a 128x64px dot matrix. This display enables you to acces the menu of the 3d printer firmware to control the function of the printer. With the SD card reader you can load gcode data from a SD card and...
€29.50 *
Arduino Mega 2560 R3 (clone) Arduino Mega 2560 R3 Board (clone) The Arduino Mega is a microcontroller board based on the ATmega2560. It has 54 digital input/output pins (of which 14 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16...
€18.95 *
RepRap RAMPS 1.4 Arduino Shield RepRap RAMPS 1.4 Arduino Shield RAMPS is short for RepRap Arduino Mega Pololu Shield. It is designed to fit the entire electronics needed for a RepRap in one small package for low cost. RAMPS interfaces an Arduino Mega with its powerful...
€14.90 *
LCD Smart Controller (with wiring) RepRap LCD Smart Controller 20x4 characters display The LCD Smart Controller is a cost efficient way to use your RepRap 3d printer autonomous. With the encoder you can step through the menue items of the printer firmware and control the...
€19.50 *
Viewed